Project overview
In January of 2026, Hernado Inc was in Kona, HI completing a project that at Kona International Airport. the primary scope of our work focused on the parking lots: Public Main Lot, Employee Lot, and the Rental Car Lot.
Below is a video and descriptions of the services provided within the respected Lots.
Featured Projects
Scope of Work for Kona Project:
Public Main Lot
Employee Lot
Rental Car Lot
Extra Services
Installation of:
- (4) Cameras, (1) Enclosure, (1) Gate Arm, (1) KISI Controller, (1) Entry Pedestrian Door for Access, (3) Custom Poles Main Entry.
- (1) Enclosure and Mount Antenna
- Provide 20v to the enclosure power which will be pulled from the existing circuit near the location
- (4) Cameras and provide conduit pathways to each of them
- CAT6 to each of the cameras from the enclosure and terminate ends
- (2) Barrier arms and provide a conduit pathway to the gate
- 18/2 control wire from enclosure to gate and terminate wires
- Power on system and test to ensure proper voltage
- (1) 4"x4"x9" custom pole on existing island.
Installation of:
- (3) Cameras, (1) Enclosures, (1) Gate arm, (1) KISI Controller for (1) Entry
Pedestrian door for assess, (3) Custom Poles Main Entry
- Install (1) Enclosure and mount antenna.
- Provide 120 V to the enclosure power will be pulled off of an existing circuit near the enclosure location.
- Install (3) cameras and provide conduct pathways to each of them.
- Provide an install Cat6 to each of the cameras from the enclosure and terminate ends
- Control (2) Barrier arm and provide a conduit pathway to the gate.
- Provide an install 18/2 control wire from enclosure to gate and terminate wires
- Power on system and test ensure there is proper voltage
- Adjust and aim camera with Metropolis
- Install (1) 4"x4"x9' custom pole on the existing island
Installation of:
- (2) Cameras, (1) Enclosures, (1) Gate arm, (1) KISI Controller for (1) Entry
Pedestrian door for assess, (3) Custom Poles
Main Entry
- Install (1) Enclosure and mount antenna.
- Provide 120 V to the enclosure power will be pulled off of an existing circuit near the enclosure location.
- Install (2) cameras and provide conduct pathways to each of them.
- Provide an install Cat6 to each of the cameras from the enclosure and terminate ends
- Control (2) Barrier arm and provide a conduit pathway to the gate.
- Provide an install 18/2 control wire from enclosure to gate and terminate wires
- Power on system and test ensure there is proper voltage
- Adjust and aim camera with Metropolis
- Install (1) 4"x4"x9' custom pole on the existing island
-Build Concrete curbs in order to mount post for
cameras 40' back from exit gate
-In order to build curb existing asphalt will be saw cut and removed and trench for conduits in ground installing curb with base and rebar
- (13) camera vision installation with (4) enclosures
- 10x custom camera poles
- 12x bollards @ 800 each
- 1x trenching, and concrete work @ 22k